Deploy Device Protection with Addigy

Use Addigy to deploy Aikido Device Protection across your managed macOS fleet with the required permissions in place.

Installation

1. 1

   What you'll need

   Before starting, make sure you have the following from the Aikido Device Protection dashboard:

   • The Aikido Device Protection .mobileconfig (downloaded from the Aikido Device Protection dashboard)
   • The Aikido Device Protection installer (.pkg file, downloaded from the dashboard)

   If you're missing any of these, go back to the Aikido Device Protection dashboard, click Connect Device, and complete the pre-flight steps.

2. 2

   Add the Aikido Device Protection configuration profile

   1. In the Addigy console, go to Catalog → Device Settings.
   2. Click New, then select Custom Profile.
   3. Upload the .mobileconfig file and give the profile a name (e.g. "Aikido Device Protection").
   4. Click Save.
   5. Click the three dots (...) next to the profile, select Assignments, choose your target policy, and click Save.

   This profile allows the Aikido Device Protection system extension to load silently, enables the network content filter, and stops users from disabling background services in System Settings → Login Items.

3. 3

   Upload and configure the Aikido Device Protection installer

   1. In the Addigy console, go to Catalog → Software → Smart Software.
   2. Click New and give the item a name (e.g. "Aikido Device Protection").
   3. Click Select File(s) to open the File Manager and upload the Aikido Device Protection .pkg.
   4. Select the uploaded file to attach it to the item.
   5. Click Auto-fill under Install Command. Addigy generates the installer command automatically.
   6. Click Save.
   7. Click the three dots (...) next to the Smart Software item, select Assignments, choose the same target policy, and click Save.
4. 4

   Deploy to your devices

   1. Verify the Aikido Device Protection configuration profile is installed: open the profile in Catalog → Device Settings and confirm the assignment status shows all target devices.
   2. Trigger the Aikido Device Protection Smart Software deployment by assigning it to the policy (or letting the next policy check-in run).
5. 5

   Reboot devices after installation

   Restart your target devices after the agent installation completes. In Addigy, you can do this per device via GoLive → Device Status → Device Commands → Restart. The agent fully activates on the next boot.

6. 6

   Verify the deployment

   On a test device, confirm:

   1. The system extension is activated:

      systemextensionsctl list | grep aikido

      Expect to see the extension marked [activated enabled].

   2. Open System Settings → General → Login Items & Extensions and confirm the Aikido Device Protection entries cannot be toggled off.

Troubleshooting